Manual Noodle Making Machine is suitable for making noodles at home, with easy operation and good quality. Saving time and labor than making noodle by hand.

 Working Flow
 

1. Mixing Flour: Add warm water into flour(about 2:5),  can put suitable amount salt, alkali; 

2. To reconcile good dough into pieces (about 20 mm), sprinkle dry flour.

3. Before using, should check the work surface, clean the dirt, add some oil in the surface of the knife sleeve and the gear.

4. Rolling noodle: First remove the dough scraper, regulating the regulator in noodle roller to 2.5-3mm, plug in 220V power supply, press switch on the machine, put the mixed dough into the bucket, repeated pressing for 4-5 times,. At last, adjust the noodle roller to 1.5mm and re-pressing for one time.

5. Cutting noodle: Install noodle cutting knife, according to need adjustment section knife regulator

6. End: after use, turn off the machine, pull off the plug, clean the body, the knife, roll.

 

Note:
 

1. The voltage must be consistent with the requirements

2. When the load is running, the minor section can not be adjusted.

3. When the minor section box starts to change, it needs to be converted to the place.

4. During operation, should avoid contact between hands with the knife and roller, so as to avoid danger, and to pay special attention to avoid children's operation.

5. The machine is equipped with a thermal protection device, when the continuous working time is too long to make the motor overheat, the heat protector action to stop the machine, the power should be cut off, normal operation after cooling of the motor.